Electronics, Embedded Systems, and Software are my breakfast, lunch, and dinner.
Feb 03, 2012
Since I never quite finished the story about my dot matrix clock, I see no reason why I shouldn't write a bit of a continuation of my current developments. Shortly before I left on my mission for my church in November 2009, I received my boards for the dot matrix clock and assembled them. However, I ran into a problem: The displays would turn off after the voltages on the gates of the row driving mosfets reached a certain voltage and when the voltage was at a level where it would turn on the display, it had some problems with turning on and off the LEDs. Now, after I left on my mission I would think about this once in a while and I figured out the problem: I was using N-Channel mosfets with only 5V or less of gate driving voltage so they wouldn't turn on/off all the way. I am sure there are more problems than just that, but I keep kicking myself for using N-Channel mosfets instead of using P-Channel. Had I used P-Channel, the problem would have been avoided and this whole thing would have worked great. For the moment, however, this project is on hold since I am designing and building a few things that I will need in the long term here at college since I can't lug around a power supply and an oscilloscope.
So, in summary, if I were to do a re-design I would change the following:
Now all that is left for me to do is to figure out how I can modify the boards I have so that I wouldn't have to drop $70 again...